Transition Networks SDSFE31XX-100 Manuel d'utilisateur télécharger pdf (Page 25)

SDSFE31xx-100 Industrial Device Server Transition Networks

24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600

Connecting power to the Device Server, continued

CAUTION

When connecting DC power wires to the terminal-block plug, pay close

attention to the polarity markings shown near the terminal block of the Device

Server. Failure to observe this caution could result in damage to the device.

Terminal-block

plug wiring

To wire the six-contact-terminal-block plug for redundant power, do the following:

Note: The six-contact-terminal-block plug is constructed (keyed) to mate with the

Device Server terminal block. When wiring the plug for power, use the

polarity markings next to the terminal block on top of the Device Server to

ensure proper connection.

Step Action

1. Turn the external power source OFF.

2. Strip the power wires as required.

3. Insert one stripped power wire into the terminal-block plug, Observe

polarity. See Figure 7.

4. Secure the wire using a flathead screwdriver by tightening the contact

screw. See Figure 7.

5. Repeat Steps 3 and 4 until all wires are installed and secured.

Figure 7: Six-Contact-Terminal-Block Plug (Primary/Redundant Power Wiring)

Continued on next page

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 85 86

Pas de commentaire

Transition Networks SDSFE31XX-100 Manuel d'utilisateur Page 25